MS-1INSTALLATION & OPERATION GUIDEMODELMS-1MICROSENSOR™MINIATURE INFRARED SENSORMS-1
9MINIATUREINFRAREDSENSORInstallationIf you are installing the MS-1 into an existing wall, take timeto consider any possible obstructions which may be
MS-1 Wiring ConfigurationPIN 1 = Red (+12V DC)PIN 2 = Bare (GND)*PIN 3 = Black (DATA)NOTE: The color code shown above is for West Penn D291IR ca
OperationThis manual contains instructions for the MS-1 only. For spe-cific information on the adjustment and operation of yourNiles Infrared system,
TroubleshootingThe "flash-back" LED on the front of the MS-1 is a useful troubleshooting aid. The LED should light only when a remote comman
MINIATUREINFRAREDSENSOR13There are many methods for reducing interference. Whichsolution is best for you depends on your situation. ContactNiles Techn
MINIATUREINFRAREDSENSOR14SpecificationsIR SystemCompatible with virtually all brands of remotes using carrierfrequencies between 18 and 100 kHzIR Rece
Niles Audio Corporationwww.nilesaudio.com12331 S.W. 130 Street Miami, Florida, 33186Tel: (305) 238-4373Fax: (305) 238-0185©1999 Niles Audio Corporatio
IntroductionThe MS-1 is a miniature IR sensor designed for use with theNiles Infrared Repeating systems.Installed in a remote room location, the MS-1
Features and BenefitsThe MS-1 offers a number of improvements over otherminiature IR sensors.●Small size of only 1/2" diameter by 2-5/16" lo
Installation ConsiderationsType of CableThe MS-1 connects to the Niles Infrared Systems with anindividual home run of 2-conductor shielded cable.Recom
Receiving Range and Pickup AngleThe receiving range of the MS-1 will vary according to the IRoutput strength of the remote control being used. Remotes
Avoiding Electrical InterferenceAvoid locating the MS-1 near any potential sources of electri-cal or optical noise, such as light dimmers, florescent
Avoiding Optical FeedbackIf installing the MS-1 in the same room as an IR flasher, it ispossible for the flasher's IR output to be picked-up by t
2. Hold the MS-1 so that the front of it is facing you, mak-ing sure that the lens is in place. Screw the new bezel ontothe MS-1 by turning it clockwi
8MINIATUREINFRAREDSENSOR(a) Hex Nut (supplied)(b) Washer (supplied)(c) Mounting Surface(d) IR Cable (10 feet supplied)(e) MS-1 Miniature IR Sensor (
Kommentare zu diesen Handbüchern